Armus hull pro
A full-performance, clear protective hull coating
Hull Pro applies easily to your hull. Unlike other antifouling paint, Hull Pro is environmentally friendly two-component epoxy material lays out quickly and self-levels. It’s so simple you can do it yourself. Check out our application guides and videos below. Contact us with any detailed questions you may have!
If you take care of your Hull Pro-coated hull, our formulation takes care of you. Regular maintenance and cleaning is still recommended on your boat or pontoon, and your cleaning frequency will depend on your water type and your growth rate. Download our helpful post-application care guide and keep it handy!
APPLICATION & MAINTENANCE GUIDES
Application - Metal
Application - Gelcoat
Care & Maintenance
- 8" TFT LCD panel, LED Backlit
- Widescreen aspect ratio 5:3
- 800 x 480 pixels
- 1350 nits brightness (Optically bonded)
- Solid state disk drive
- Fanless cooling system
- Flush or VESA mounting capability
- Dual CAN Bus for Single or Redundant NMEA 2000® Network Connectors
TECHNICAL INFORMATION
| Type | Silicone epoxy |
| Color | Clear |
| Components | Part A (Base) + Part B (Hardener) |
| Mixing Ratio | 4:1 A:B per volume |
| VOC Content | <240 g/L |
| Solids by Volume | 80% |
| Flash Point | >140°F (60°C) |
APPLICATION INFORMATION
| Coverage (Single-application) |
8.5oz Kit - ~7.5 linear feet of vessel hull 17 oz Kit - ~15 linear feet of vessel hull 32 oz Kit - ~23 linear feet of vessel hull |
| Application Temperature | 41–95°F (5–35°C) |
| Substrate Application Temperature |
41–95°F (5–35°C) Surface temp should be a min of 5°F greater than the dew point. |
| Maximum Pot Life | ~45 min @ 68°F (20°C) |
| Touch-Dry Time | 3 h @ 68°F (20°C) |
| Dry Through Time / Curing Time | ~24 h @ 68°F (20°C) |
| Minimum Recoat Interval | ~24 h @ 68°F (20°C) |
| Minimum Time to Launch | ~72 h @ 68°F (20°C) (48 hours after full cure) |
-
PRODUCT DOCUMENTS
Product Sheet
Technical Data Sheet
Safety Data Sheet
HULL PRO COVERAGE CALCULATOR
We’ve created a helpful guide for calculating how much Hull Pro you need for your vessel.
NOTE: Estimate based on roller and tipping brush application.
Lower units: Add one 8.5oz kit per twin engine rig.
(using whole numbers between 15 and 60)
Contact
